MG 1100 and 1300 (ADO16) (1962 – 1971) Review

MG 1100 and 1300 (ADO16) (1962 – 1971) At A Glance

+Good roadholding and ride, great steering, many parts shared with the Mini

-Rust and difficult servicing

The fabulous Austin and Morris 1100 (ADO16) may have seemed like an unlikely starting point for an MG sports saloon, but actually, but when badge engineered to wear the octagon, it worked very well indeed. But then, the starting point was absolutly perfect - the ADO16 had tenacious front-wheel-drive handling, just like a big Mini.

The well-appointed interior added to the MG 1100's appeal, thus creating a genuinely sporting saloon - or a 'warm hatch' as it would no doubt be called now. It wasn’t perfect, though – it proved difficult for mechanics to work on, and had a terrible reputation for rust, which was rightly deserved.

Survival rate is low considering the huge number produced, but those that are left are not expensive to buy, and cost peanuts to run - as long as they're half way to being rot-free.

Join the club

Honest John Classics has teamed up with MG Car Club (the world's oldest MG club) to offer readers £5 off single and joint memberships. Joining the club means joining the largest group of MG fans in the world and getting access to first-rate technical knowledge as well as the chance to save money on your insurance premiums. Simply visit www.mgcc.co.uk/join and use the code HONEST5. (Disclaimer: if you join Honest John receives a small fee).

Ask Honest John

My MG 1100 has cracked underneath and come away from the body. Can it be repaired?

"My 1968 MG 1100 has cracked underneath and come away from the body. Can it be repaired? It is made of what looks like a hard cardboard. Could I buy a replacement? The only metal under the car is the exhaust that sits into a curved out piece from front to back. It will have a metal frame and seat plates under the cardboard but I have not taken it off completely. I hit a pot hole going over a speed bump and it ripped coming away from the body under the driverside door and has a small rip. This caused the exhaust to drop to the floor. Luckily I was going slow and stopped. I think the seat plate under the drivers seat might have dropped. I have asked about garages but no one has a clue."
If you're referring to the floor of your car, that definitely shouldn't be made of hard cardboard - it should all be metal and the seat should not be going through the floor. I think you have to err on the side of caution here and transport it to a local garage to be inspected on a ramp - any local garage can do this. The 1100 Club (www.the1100club.com) is extremely helpful, so it's worth getting in touch. They also have parts in stock, such as floorpans and sills, handy if the worst comes to the worse and the car does need welding.
Answered by Keith Moody
More Questions